Pearson Carbon Flared Gravel Handlebar

Handlebar · Pearson

Pearson Carbon Flared Gravel Handlebar

£170

Will it fit my Pearson?

Fits every Pearson. Forge, Shift 2.0, On&On Adventure and On&On Race.

Standard on every On&On.

Not sure what your bike has? Send your frame number to [email protected] and the workshop will check.

Reach

75mm

Drop

125mm

Flare

12 degrees

Material

Carbon

The details

The flared bar every On&On is built with.

The flared carbon bar every On&On leaves the build shop with. The drops flare out 12 degrees, so they sit wider than the hoods; many riders go one width narrower than their road bar. It fits every Pearson, with the Pearson carbon stem.

75mm reach and 125mm drop, in 380, 400 and 420mm.

Often fitted with

Finish the job

Stem · Pearson Pearson Carbon Stem £130✓ Fits every PearsonStandard with the two-piece bars.

Bar tape · Fizik Fizik Terra Bondcush Tacky Bar Tape £35

Headset · Pearson Pearson Two-Piece Engraved Headset Top Cover £15✓ Fits every PearsonFor the two-piece bar and stem.

On the bike

How it looks fitted

Width

380mm, 400mm or 420mm, measured at the hoods

Reach

75mm

Drop

125mm

Flare

12 degrees (at the drop); the drops sit roughly 53mm wider than the hoods for control on rough ground

Material

Carbon

Will this fit my Pearson?

Each part lists the Pearson models and model years it suits in the description and key features. If you are unsure, send us your frame and model year and we will confirm the right part before you order.

Will it fit frames from other brands?

Many of our cockpit and finishing parts use standard fittings, such as a 1 1/8 inch steerer, so they work on a wide range of frames. Check the key features for the exact standard, and ask us if you need to be certain.

What torque should I use when fitting it?

Where a torque figure applies it is listed in the key features. Carbon parts in particular should be fitted to the stated torque with a calibrated torque wrench to avoid damage. If in doubt, have a bike shop or one of our retail partners fit it.

Can someone fit it for me?

Yes. Any good bike shop or one of our retail partners can fit it, and we’re happy to talk them through it. If you’re ordering a new bike, ask us and we can fit the part as part of your build.

How do I look after carbon components?

Always fit carbon parts to the recommended torque, use carbon assembly paste where appropriate and avoid clamping outside the marked areas. Inspect them regularly and replace anything that has taken a hard knock.

Are the fitting bolts included?

Replacement parts come with the bolts and small fittings needed for a straightforward swap unless the description says otherwise. If anything is missing, contact us and we will put it right.